P0014 on Volkswagen
Exhaust Camshaft Position Timing - Over-Advanced (Bank 1)
P0014 on Volkswagen vehicles indicates exhaust camshaft position timing - over-advanced (bank 1). Au7o has documented this code across 7 Volkswagen models — most commonly on Atlas, Beetle, CC. P0014 means the exhaust camshaft on bank 1 is timed too far advanced — the variable valve timing (VVT) system has moved the cam beyond the position the computer commanded, or it's stuck in an over-advanced position. The engine uses VVT to rotate the camshaft and optimize valve timing for power, economy, and emissions; the computer compares the commanded cam position to the actual reading from the cam sensor and flags this code when they don't agree. Common results are rough idle, reduced power, poor fuel economy, or a rattle at start-up. Oil flow and the VVT actuator are the usual suspects. Typical repair costs on Volkswagen range from $800 to $4,500, depending on the specific model and root cause.
Common Causes of P0014
- •Low or dirty engine oil restricting VVT operation
- •Stuck or failed camshaft oil control valve (VVT solenoid)
- •Clogged VVT solenoid screen or oil passages
- •Faulty camshaft phaser/actuator
- •Wiring or connector fault at the oil control valve
- •Stretched timing chain or jumped timing
- •Camshaft position sensor fault giving incorrect reading
P0014 on Volkswagen by Model
Volkswagen Atlas(1 issue)
- VR6 3.6L Timing Chain Stretch and Rattle2018-2024
The 3.6L VR6 engine in the Atlas can develop timing chain stretch, causing a rattle on startup and potential engine damage. The VR6 uses two timing chains (upper and lower) with hydraulic tensioners. The upper chain and tensioner are more prone to wear. Oil change neglect accelerates chain stretch. VW issued TSB 15-18-03 for timing chain noise diagnosis. The issue is more common after 60,000 miles.
Volkswagen Beetle(1 issue)
- 2.5L 5-Cylinder Timing Chain Tensioner Failure2006-2019
The VW Beetle with the 2.5L 5-cylinder engine (07K) suffers from timing chain tensioner failures that allow the chain to skip teeth, causing catastrophic engine damage. The tensioner uses a ratcheting mechanism that can fail, particularly during oil pressure drops at cold start. This issue affects all 2.5L Beetles, including the New Beetle (2006-2010) and the modern Beetle (2012-2019). VW released an updated tensioner but did not issue a recall.
Volkswagen CC(1 issue)
- EA888 2.0T Timing Chain Tensioner Failure2009-2015
The CC with the EA888 2.0T engine (Gen1 and Gen2) shares the timing chain tensioner defect common to all EA888 engines. The tensioner can fail and allow the chain to skip, causing catastrophic valve and piston damage. The CC models from 2009-2012 are most at risk as they use the earliest tensioner revisions. VW updated the tensioner design multiple times, with revision K being the final fix.
Volkswagen Eos(1 issue)
- EA888 2.0T Timing Chain and Tensioner Failure2008-2016
The Eos with the EA888 2.0T engine shares the timing chain tensioner defect common across the VW/Audi 2.0T platform. The tensioner can fail, allowing the chain to skip teeth and cause catastrophic valve damage. The Eos tends to have less frequent oil changes due to being a secondary/weekend car for many owners, which accelerates tensioner wear.
Volkswagen Golf(1 issue)
- EA888 Gen1/Gen2 Timing Chain Tensioner Failure2008-2014
The EA888 2.0T engine (Gen1 and Gen2) in 2008-2014 Golf/GTI models suffers from a faulty timing chain tensioner that can fail and allow the chain to skip teeth. This can cause catastrophic engine damage including bent valves and piston contact. VW updated the tensioner design multiple times (revision K is considered the final fix). The original tensioner (part# 06K-109-467-K) was revised after widespread failures reported at 40,000-80,000 miles.
Volkswagen Jetta(1 issue)
- Timing Chain Tensioner Failure (TSI)2008-2016
The EA888 2.0T TSI engine (Gen 1 and early Gen 2) is notorious for timing chain tensioner failure. The tensioner can fail, allowing the timing chain to skip teeth, which can cause catastrophic engine damage. This is most common on engines produced before 2013.
Volkswagen Passat(1 issue)
- 1.8T/2.0T EA888 Timing Chain Stretch2012-2018
The EA888 1.8T and 2.0T engines in the 2012-2018 Passat can experience timing chain stretch, particularly in the Gen1 and Gen2 variants. The chain elongates over time due to inadequate tensioner design and oil starvation. This causes camshaft timing to shift, triggering check engine lights and eventually leading to catastrophic engine failure if the chain jumps teeth. The problem is most common with infrequent oil changes or use of non-VW spec oil.
Looking for P0014 on a different make?
View P0014 across all makes →Frequently Asked Questions
What does P0014 mean on Volkswagen?▼
P0014 stands for "Exhaust Camshaft Position Timing - Over-Advanced (Bank 1)." P0014 means the exhaust camshaft on bank 1 is timed too far advanced — the variable valve timing (VVT) system has moved the cam beyond the position the computer commanded, or it's stuck in an over-advanced position. The engine uses VVT to rotate the camshaft and optimize valve timing for power, economy, and emissions; the computer compares the commanded cam position to the actual reading from the cam sensor and flags this code when they don't agree. Common results are rough idle, reduced power, poor fuel economy, or a rattle at start-up. Oil flow and the VVT actuator are the usual suspects. On Volkswagen specifically, this code is documented across 7 models.
What causes P0014 on Volkswagen vehicles?▼
Common causes on Volkswagen: Low or dirty engine oil restricting VVT operation, Stuck or failed camshaft oil control valve (VVT solenoid), Clogged VVT solenoid screen or oil passages, Faulty camshaft phaser/actuator, Wiring or connector fault at the oil control valve. Specific causes vary by model and year — see the per-model sections below.
How much does it cost to fix P0014 on a Volkswagen?▼
Repair costs on Volkswagen range from $800 to $4,500, depending on the specific model and root cause.
Which Volkswagen models have P0014 documented?▼
Au7o has documented P0014 on 7 Volkswagen models: Atlas, Beetle, CC, Eos, Golf, Jetta, Passat.