P0307 on RAM
Cylinder 7 Misfire Detected
P0307 on RAM vehicles indicates cylinder 7 misfire detected. Au7o has documented this code across 4 RAM models — most commonly on 1500, 1500 Classic, 2500. P0307 means the engine computer detected a misfire on cylinder number 7 — that cylinder isn't burning its air/fuel mixture completely or at the right moment. The PCM senses this by watching for tiny slowdowns in crankshaft speed each time cylinder 7 should fire. A misfire wastes fuel, can dump raw fuel into the exhaust, and may damage the catalytic converter over time, which is why a persistent or severe misfire often makes the check engine light flash. You may feel rough idle, shaking, hesitation, or a loss of power. Typical repair costs on RAM range from $200 to $12,000, depending on the specific model and root cause.
Common Causes of P0307
- •Worn, fouled, or incorrectly gapped spark plug on cylinder 7
- •Failed ignition coil or coil-on-plug for cylinder 7
- •Faulty, clogged, or leaking fuel injector
- •Vacuum or intake air leak affecting that cylinder
- •Low compression (worn rings, burnt/leaking valve, head gasket)
- •Damaged spark plug wire or boot (on applicable engines)
- •Carbon buildup or sticking valve
P0307 on RAM by Model
RAM 1500(2 issues)
- HEMI Lifter/Camshaft Failure2009-2019
The 5.7L HEMI engine with Multi-Displacement System (MDS) can experience premature lifter and camshaft wear. The MDS deactivation lifters are prone to failure, causing ticking, misfires, and in severe cases, camshaft lobe damage. This issue has led to class action lawsuits.
- 5.7L HEMI Dropped Valve Seat (Pre-2009 Engines) Causing Misfire and Catastrophic Engine Damage2003-2008
On 2003-2008 5.7L HEMI engines the cylinder-head valve-seat bores were machined without sufficient interference fit. Combined with localized coolant boiling and hot spots in the heads, an exhaust or intake valve seat can spin loose and drop into the combustion chamber. When the seat drops it is hammered by the valve and piston, causing a sudden misfire, loss of power, a heavy metallic knock, and in many cases destruction of the piston, valve and head. This is distinct from the well-known exhaust-manifold-bolt tick and the later MDS lifter/cam failure; it is a structural cylinder-head defect specific to pre-2009 (pre-Eagle) HEMIs. Overheating events dramatically raise the risk. The 2009 Eagle HEMI revision used improved seat material and tighter machining and largely eliminated the failure.
RAM 1500 Classic(2 issues)
- 5.7L HEMI MDS Lifter Failure2019-2024
The 5.7L HEMI with Multi-Displacement System (MDS) in the 1500 Classic develops lifter failure, particularly on cylinders that deactivate. The roller lifters can collapse or seize, causing ticking noise and misfires. This is the same issue as the standard 1500.
- MDS Lifter Failure and Hemi Tick (5.7L)2019-2025
The 5.7L Hemi V8 uses Multi-Displacement System (MDS) hydraulic lifters to deactivate four cylinders during light-load cruising. The MDS lifters are known to fail, causing a persistent ticking noise (the infamous "Hemi tick") and misfires on the deactivated cylinders. When an MDS lifter collapses or sticks, it cannot properly deactivate and reactivate the valve, leading to a dead cylinder. In severe cases, a failed lifter can damage the camshaft lobe, requiring a complete top-end rebuild.
RAM 2500(1 issue)
- 6.4L HEMI Valvetrain Failure (Roller Lifter/Camshaft Wear, "HEMI Tick")2014-2024
Gas RAM 2500s with the 6.4L (392) HEMI V8 suffer a documented valvetrain defect in which the roller lifter needle bearings fail, the roller stops rolling and drags across the camshaft lobe, wiping out the lobe. The failure is linked to the truck's Multi-Displacement System (MDS/cylinder deactivation): when cylinders are deactivated, oil delivery to the affected lifters is restricted, starving the roller bearings. Owners report onset as a metallic 'HEMI tick' progressing to misfire, dropped cylinder and catastrophic top-end damage. A class-action lawsuit (Petro, et al. v. FCA US LLC, Case No. 1:22-cv-00621, whose named plaintiffs include a 2020 RAM 2500 owner) alleges FCA knew of the defect since at least 2012 and failed to disclose it. There is no safety recall, so repairs typically fall on the owner once warranty lapses.
Looking for P0307 on a different make?
View P0307 across all makes →Frequently Asked Questions
What does P0307 mean on RAM?▼
P0307 stands for "Cylinder 7 Misfire Detected." P0307 means the engine computer detected a misfire on cylinder number 7 — that cylinder isn't burning its air/fuel mixture completely or at the right moment. The PCM senses this by watching for tiny slowdowns in crankshaft speed each time cylinder 7 should fire. A misfire wastes fuel, can dump raw fuel into the exhaust, and may damage the catalytic converter over time, which is why a persistent or severe misfire often makes the check engine light flash. You may feel rough idle, shaking, hesitation, or a loss of power. On RAM specifically, this code is documented across 4 models.
What causes P0307 on RAM vehicles?▼
Common causes on RAM: Worn, fouled, or incorrectly gapped spark plug on cylinder 7, Failed ignition coil or coil-on-plug for cylinder 7, Faulty, clogged, or leaking fuel injector, Vacuum or intake air leak affecting that cylinder, Low compression (worn rings, burnt/leaking valve, head gasket). Specific causes vary by model and year — see the per-model sections below.
How much does it cost to fix P0307 on a RAM?▼
Repair costs on RAM range from $200 to $12,000, depending on the specific model and root cause.
Which RAM models have P0307 documented?▼
Au7o has documented P0307 on 4 RAM models: 1500, 1500 Classic, 2500.