P0462 on RAM
Fuel Level Sensor 'A' Circuit Low Input
P0462 on RAM vehicles indicates fuel level sensor 'a' circuit low input. Au7o has documented this code across 1 RAM model — most commonly on 1500. P0462 indicates the powertrain control module detected a fuel-level sensor signal voltage that is lower than the normal operating range — often interpreted as an empty or near-empty reading that may not reflect the actual fuel amount. The fuel level sender reports tank level via a variable resistance, and an abnormally low signal can stem from a short to ground or a failed sender. This usually shows up as a stuck-low or inaccurate fuel gauge rather than a driving problem. It is low-urgency but should be corrected so the gauge and EVAP monitors work properly. Typical repair costs on RAM range from $150 to $500, depending on the specific model and root cause.
Common Causes of P0462
- •Faulty fuel level sensor / sending unit
- •Short to ground in the signal wire
- •Corroded or damaged connector at the fuel pump module
- •Open or high-resistance ground circuit
- •Worn sender resistor card or float
- •Damaged wiring harness to the tank
- •Instrument cluster or PCM fault (less common)
P0462 on RAM by Model
RAM 1500(1 issue)
- Fuel Level Sending Unit Failure — Inaccurate, Stuck, or Erratic Fuel Gauge1994-2010
The in-tank fuel level sending unit (float arm and variable-resistor card, part of the fuel pump module) wears out and gives false readings — commonly reading full then dropping to empty, sticking, or bouncing. On OBD-II trucks it sets P0463/P0462. It is one of the most-searched Ram gauge complaints and is separate from the instrument-cluster fault.
Looking for P0462 on a different make?
View P0462 across all makes →Frequently Asked Questions
What does P0462 mean on RAM?▼
P0462 stands for "Fuel Level Sensor 'A' Circuit Low Input." P0462 indicates the powertrain control module detected a fuel-level sensor signal voltage that is lower than the normal operating range — often interpreted as an empty or near-empty reading that may not reflect the actual fuel amount. The fuel level sender reports tank level via a variable resistance, and an abnormally low signal can stem from a short to ground or a failed sender. This usually shows up as a stuck-low or inaccurate fuel gauge rather than a driving problem. It is low-urgency but should be corrected so the gauge and EVAP monitors work properly. On RAM specifically, this code is documented across 1 model.
What causes P0462 on RAM vehicles?▼
Common causes on RAM: Faulty fuel level sensor / sending unit, Short to ground in the signal wire, Corroded or damaged connector at the fuel pump module, Open or high-resistance ground circuit, Worn sender resistor card or float. Specific causes vary by model and year — see the per-model sections below.
How much does it cost to fix P0462 on a RAM?▼
Repair costs on RAM range from $150 to $500, depending on the specific model and root cause.
Which RAM models have P0462 documented?▼
Au7o has documented P0462 on 1 RAM model: 1500.