P2419 on Toyota: How to Diagnose & Fix
Evaporative Emission System Switching Valve Control Circuit Low
2 Toyota models · 2 documented issues · $150-$500 repair
P2419 on Toyota by model: symptoms, diagnosis and fix
Toyota T-SB-0046-10 applies to specified 2006-2010 RAV4 production and addresses liquid fuel entering the EVAP system. The documented gates are an illuminated MIL with DTC P043E, P043F, P2401, P2402 and/or P2419, or an intermittent warm rough idle reproduced while commanding the purge VSV, followed by physical confirmation of fuel in the applicable EVAP vent hoses. It is not a general 2001-2012 charcoal-canister failure card and does not support the old P0440/P0441/P0442/P0446/P0455 mapping.
Common Symptoms
- MIL with one or more supported EVAP DTCs
- Intermittent rough idle at operating temperature during the bulletin's purge-VSV test
- Liquid fuel physically confirmed in a specified EVAP vent hose
How to Fix
Follow T-SB-0046-10's sequence: check for the supported DTCs; if none are stored, active-test the purge VSV at warm idle; then disconnect and inspect the specified tank-to-canister and canister-to-key-off-pump hoses for liquid fuel. If the gates are not met, the bulletin does not apply and normal EVAP diagnosis continues. If fuel is confirmed, the required tank, canister and possibly canister-filter/protector scope depends on which hose contains fuel. Do not replace a gas cap, vent valve or full canister from a generic code list. The former federal and California emissions-warranty windows are expired; obtain a diagnosis and estimate first.
Owner tips & cautions
- TipSave freeze-frame data and all EVAP codes before clearing them; the bulletin requires exact code/test and liquid-fuel confirmation gates.
- WarningDo not guess at an EVAP canister, gas cap or vent valve from a generic code; T-SB-0046-10's component scope changes based on where liquid fuel is found.
Sources for this issue (1)
Third-generation Siennas commonly throw EVAP (evaporative emissions) faults as the system ages. Failure points include the canister vent solenoid/VSV sticking, the leak-detection pump and reference orifice, the purge valve, and a worn or loose gas cap. Beyond the check engine light and an emissions/smog failure, a stuck-closed vent can make the tank hard to refuel (pump clicks off repeatedly), while a stuck-open vent or cracked line can produce a fuel-vapor smell.
Common Symptoms
- Check engine light with EVAP codes
- Fails state emissions/smog test
- Gas pump clicks off repeatedly / difficult to refuel
- Faint fuel-vapor smell near the vehicle
- No drivability change but persistent CEL
How to Fix
Check the gas cap first, then smoke-test the EVAP system to find leaks. Codes guide the fix: P043E/P043F point to a clogged or ruptured reference orifice, P2401/P2402/P2419 to the leak-detection pump/switching valve, and P0441/P0446/P0455 to purge/vent flow or large leaks. Typical repairs (vent solenoid, purge VSV, leak-detection pump, or hoses) run roughly $150-$500 including diagnosis.
What you need to fix it
Only diagnosis- and fitment-reviewed repair parts are linked here.
- Toyota 77300-06040 fuel tank cap assembly
replace a cap that fails seal, tether or ratchet inspection on the matching early branch Fitment/availability: Early fuel-cap branch cataloged for Sienna through the relevant early third-generation production; confirm VIN and production …
- Toyota 77300-07030 fuel tank cap assembly
replace a cap that fails inspection on the matching middle production branch Fitment/availability: Middle fuel-cap branch cataloged for 2013-2017 Sienna with production-date overlap; confirm VIN against the catalog before ordering Fitmen…
- Toyota 77300-07040 fuel tank cap assembly
replace a cap that fails inspection on the matching late production branch Fitment/availability: Late fuel-cap branch used from the applicable 2016/2017 production change through 2020; confirm VIN and build date Fitment/availability: Shi…
- Toyota 77740-08070 charcoal canister assembly
replace the early canister only after smoke/active testing confirms its internal pump, orifice, vent or canister failure Fitment/availability: Canister branch cataloged for 2011-2016 Sienna and some 2017 applications; confirm VIN, drivet…
- Toyota 77740-08090 charcoal canister assembly
replace the late canister only after smoke/active testing confirms its internal pump, orifice, vent or canister failure Fitment/availability: Canister branch cataloged for 2017-2020 Sienna 3.5L; confirm VIN and production because 2017 ov…
As an Amazon Associate, we earn from qualifying purchases; other part links may also earn au7o a commission. Confirm fitment by VIN before buying.
Sources for this issue (3)
P2419 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P2419 mean on a Toyota?
P2419 stands for "Evaporative Emission System Switching Valve Control Circuit Low." Generic code set when the PCM detects lower-than-expected voltage on the EVAP switching valve control circuit (short to ground or broken wire), preventing proper valve operation. On Toyota it is documented across 2 models: RAV4, Sienna.
What are the most common causes of P2419?
The most common causes of P2419 are: Short to ground or broken wire in control circuit, Failed EVAP switching valve, Connector/harness damage, PCM output driver fault. The specific cause varies by vehicle.
How much does it cost to fix P2419 on a Toyota?
Published repair estimates on Toyota range from $150 to $500 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P2419 on a different make?
View P2419 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.