00522 on Audi: How to Diagnose & Fix
Engine Coolant Temperature Sensor (G62): Open Circuit / Short to Positive (B+)
1 Audi model · 1 documented issue · $30-$180 repair
00522 on Audi by model: symptoms, diagnosis and fix
The original black-housing dual coolant temperature sensor (G62) mounted in the coolant flange at the back of the cylinder head develops cracks and fails internally. The temperature sensor G2 (also known as G62) for the gauge has likely failed and is relatively easy to fix; it is located in the coolant flange at the back of the cylinder head and the early square-connector style and later elongated D-shaped black connector sensors are known problematic units. When it fails the ECU sees an implausible coolant temperature, leading to cold starting difficulties at low temperatures, poor idle and acceleration during warm up as well as an erratic or dead temperature gauge.
Common Symptoms
- erratic or dead coolant temperature gauge
- hard cold starts
- rough idle during warm-up
- poor fuel economy
- rich-running condition
- check engine light
How to Fix
Scan with VAG-COM/VCDS for fault 17664 / 16502 (P0118) and bench-test the sensor's resistance. From Bentley, the G62 test procedure: allow engine to cool to room temp (68F/20C), disconnect ECT sensor, connect multimeter to terminals 1 and 2; resistance must be 1500 to 3000 ohms — if not, replace the ECT. Replace with the updated green-top OEM sensor (part 059 919 501A) along with the retaining clip (032 121 142) and O-ring; replacing this sensor resolves running issues for many owners who are still using the original black sensor which had a high failure rate. Part is ~$25-40, DIY 30 minutes; shop labor brings total to ~$80-180.
What you need to fix it
Only diagnosis- and fitment-reviewed repair parts are linked here.
- Engine Coolant Temperature SensorCross-refTSE 1D
Fitment confirmed against the ShowMeTheParts catalog for this vehicle's year and engine.
As an Amazon Associate, we earn from qualifying purchases; other part links may also earn au7o a commission. Confirm fitment by VIN before buying.
Sources for this issue (1)
00522 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does 00522 mean on a Audi?
00522 stands for "Engine Coolant Temperature Sensor (G62): Open Circuit / Short to Positive (B+)." This is a VAG (VW/Audi/SEAT/Skoda) fault code reported by VCDS/VAG-COM indicating a problem in the Engine Coolant Temperature Sensor (G62) circuit, specifically a break in the wiring or a short circuit to positive (B+). When this circuit fails, the ECU receives an implausible coolant temperature signal and misreads engine temperature, which causes incorrect fuel and (on diesels) glow-plug control. Typical symptoms include hard cold starting, abnormally high or irregular idle (often 1200-3000 rpm) on a warm start, and poor acceleration during warm-up. On Audi it is documented across 1 model: A4.
What are the most common causes of 00522?
The most common causes of 00522 are: Faulty Engine Coolant Temperature Sensor (G62) itself, Wiring or connector fault in the G62 circuit (chafed, damaged, or shorted to B+), Moisture/corrosion in the G62 wiring harness or connector, Broken/open wire causing loss of signal, Damaged connector or poor ground/terminal contact at the sensor. The specific cause varies by vehicle.
How much does it cost to fix 00522 on a Audi?
Published repair estimates on Audi range from $30 to $180 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for 00522 on a different make?
View 00522 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.