P0628 on 2007-2013 Chevrolet Silverado — Fuel Pump "A" Control Circuit Low
1 vehicles · 1 makes · $250-$600 repair
How to diagnose and fix P0628: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Chevrolet Silverado · 2007–2013
GMT900 Silverados (and the late GMT800) mount the fuel pump control module / fuel-system control module on an exposed frame-rail bracket where it is constantly hit with road salt, water and debris. The module's connector and internals corrode, and the FPCM then fails to drive the in-tank pump — producing extended cranking, intermittent stalling, and ultimately a crank-but-no-start with no fuel pressure. Because the pump itself is often fine, owners frequently mis-diagnose and replace the in-tank pump first. A common, well-documented salt-belt failure with steady search demand.
Common Symptoms
- Crank but no start / engine won't fire
- Extended cranking before starting
- Intermittent stalling while driving
- No fuel-pump prime sound at key-on
- Loss of power / hesitation
- Fuel-system codes / pump not commanded on
How to Fix
Diagnose by checking for fuel-pump prime/pressure and FPCM communication and inspecting the frame-mounted module connector for corrosion. The fix is to replace the corroded fuel pump control module (a new programmed module is required; GMT900 OE 20759945 / later 13543038 family) and clean/repair the connector and grounds; relocating or sealing the connector helps prevent recurrence. Rule out blown fuse/relay and a genuinely failed in-tank pump first.
Sources for this issue (1)
Find P0628 by make
Browse every documented model and issue for your make.
P0628 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0628 mean?
P0628 stands for "Fuel Pump "A" Control Circuit Low." The control module detected a low-voltage (short-to-ground) condition in the fuel pump 'A' control circuit. Signal voltage is below the expected range.
What are the most common causes of P0628?
The most common causes of P0628 are: Short to ground in the fuel pump control circuit, Faulty fuel pump relay (shorted), Damaged/corroded wiring, Poor ground, Internal PCM fault. The specific cause varies by vehicle.
How much does it cost to fix P0628?
Repair costs for P0628 range from $250 to $600, depending on the vehicle and root cause.
Which vehicles are affected by P0628?
Au7o has documented P0628 across 1 vehicle models from 1 manufacturers: Chevrolet.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.