P0652 on 2024 Hyundai Venue — Sensor Reference Voltage "B" Circuit Low
1 vehicles · 1 makes
How to diagnose and fix P0652: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Hyundai Venue · 2024–2024
A sensor inside the EGR valve may have been contaminated with solder flux during supplier manufacturing and can short. Because the EGR valve and crank position sensor share a power circuit, the short can turn on the check-engine light or cause a sudden loss of motive power, which increases the risk of a crash. Applies to: Certain 2024 Hyundai Venue vehicles with the Gamma 1.6L MPI engine built January 12 – March 4, 2024 (2,364 Venues; the recall also covers some 2024 Elantra and Kona). Hyundai campaign 260. Only a Hyundai dealer can confirm whether a specific VIN is included and whether the repair has been done.
How to Fix
Have a Hyundai dealer check the VIN for recall 24V308 (campaign 260). The remedy is replacement of the EGR valve assembly and its gasket at no cost to the owner; Hyundai also offers reimbursement for eligible out-of-pocket repairs of this condition under its plan filed with NHTSA. This is engine-bay electrical and emissions work; no DIY repair or retail part is recommended.
Sources for this issue (2)
Find P0652 by make
Browse every documented model and issue for your make.
P0652 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0652 mean?
P0652 stands for "Sensor Reference Voltage "B" Circuit Low." P0652 sets when the PCM/ECM detects that the "B" 5-volt sensor reference circuit has dropped below the expected voltage (typically a short to ground or an overloaded feed). Sensors powered by the B reference then read incorrectly, which can trigger additional sensor faults and cause the engine to run poorly or enter a fail-safe strategy.
What are the most common causes of P0652?
The most common causes of P0652 are: Short to ground in the 5V reference "B" wiring, Failed sensor on the B circuit pulling the reference low, Corroded or wet connectors creating a low-resistance path, Chafed harness contacting the chassis/ground, Internal PCM/ECM reference regulator fault. The specific cause varies by vehicle.
How much does it cost to fix P0652?
Repair costs vary widely depending on the root cause and vehicle.
Which vehicles are affected by P0652?
Au7o has documented P0652 across 1 vehicle models from 1 manufacturers: Hyundai.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.