C2417 on 2017-2022 Hyundai Ioniq — Hill Start Assist System Fault
1 vehicles · 1 makes · $400-$1,400 repair
How to diagnose and fix C2417: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Hyundai Ioniq · 2017–2022
The Hyundai Ioniq's electronic parking brake (EPB) and Auto Hold feature can malfunction randomly, illuminating the EPB warning light and disabling the Auto Hold function. The EPB system uses brushed DC motors in the rear calipers that can fail prematurely, with diagnostic code C2417 indicating a motor short or open circuit. When the EPB faults, the Auto Hold feature (which automatically holds the brake at stops) also becomes unavailable, turning orange on the dashboard. The issue can be intermittent and difficult for dealers to reproduce, as the fault codes may not store permanently.
Common Symptoms
- Electronic Parking Brake warning light illuminates randomly
- Auto Hold indicator turns orange and feature is disabled
- EPB fails to engage when shifting to Park
- Grinding or clicking noise from rear brakes when EPB activates
- Smart Cruise Control becomes unavailable when EPB faults
How to Fix
Visit a Hyundai dealer and request a scan for code C2417. If present, the rear caliper EPB motor needs replacement ($400-$700 per caliper including labor). Both rear calipers should ideally be replaced together as the motors wear at similar rates. The dealer can also perform an EPB service mode reset after replacement. If the issue is intermittent and no codes are stored, ask the dealer to note the complaint in the service record for warranty tracking. The EPB calipers and motors are covered under the factory warranty.
Owner tips & cautions
- TipIf the EPB warning comes on intermittently, take a photo or video of the dashboard every time it happens. The dealer needs evidence that the issue is recurring if they cannot reproduce it during the service visit. Date-stamped photos strengthen your warranty claim.
Sources for this issue (2)
Find C2417 by make
Browse every documented model and issue for your make.
C2417 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does C2417 mean?
C2417 stands for "Hill Start Assist System Fault." C2417 is a chassis code that the provided definition lists as a Hill Start Assist (hill-hold) system fault, a feature that briefly holds the brakes when you start off on an incline so the car doesn't roll back. The control module sets this code when it detects a problem within the hill-start-assist function or a related input it relies on, such as brake-pressure, incline, or wheel-speed data. You will typically see a warning message and lose the hill-hold feature, though normal braking still works. Note this is a manufacturer-specific code whose exact meaning and triggering component can vary by make, so the stored definition should be confirmed against the vehicle's service data.
What are the most common causes of C2417?
The most common causes of C2417 are: Fault or stored codes in the ABS/stability control module (shares the function), Faulty brake pressure or master cylinder pressure sensor, Inclination/yaw or accelerometer sensor fault, Wheel speed sensor signal problem, Brake pedal or brake light switch fault, Damaged wiring or connectors in the brake control system, Low brake fluid or hydraulic/electronic actuator issue. The specific cause varies by vehicle.
How much does it cost to fix C2417?
Repair costs for C2417 range from $400 to $1,400, depending on the vehicle and root cause.
Which vehicles are affected by C2417?
Au7o has documented C2417 across 1 vehicle models from 1 manufacturers: Hyundai.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.