P0693 on 2012-2018 Jeep Wrangler — Cooling Fan 2 Control Circuit Low
1 vehicles · 1 makes
How to diagnose and fix P0693: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Jeep Wrangler · 2012–2018
Owners of 3.6L JK Wranglers report the electric radiator fan stopping, with code P0480 and the engine overheating at idle or low speed, especially in hot weather. The 3.6L fan has its controller built into the fan assembly and runs on a power feed from the battery plus a control signal from the fuse and relay module (TIPM), so the cause can be the fan, its power or ground connection, or the signal. Applies to: 2012-2018 Jeep Wrangler and Wrangler Unlimited (JK) with the 3.6L Pentastar V6. Owner reports name a 2015 JK Unlimited and other 3.6L JKs.
Common Symptoms
- Check-engine light with code P0480
- Engine overheats when sitting still or at low speed
- Radiator fan does not spin at all
How to Fix
If the temperature climbs at idle, stop and let the engine cool rather than driving it hot. Owners report two different causes: on one 2015 JK the fault was a loose power connection at the battery (the owner suspects it was loosened during a stereo install), while other owners replaced the fan assembly, one after water and mud got into it. Have a technician check the fan's power, ground and control signal before replacing the fan or the TIPM.
Sources for this issue (2)
Find P0693 by make
Browse every documented model and issue for your make.
P0693 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0693 mean?
P0693 stands for "Cooling Fan 2 Control Circuit Low." The control module detected a low-voltage (short-to-ground or open) condition in the cooling fan 2 control circuit. The fan 2 control output is below the expected range.
What are the most common causes of P0693?
The most common causes of P0693 are: Short to ground in the fan 2 control circuit, Faulty cooling fan relay or fan motor, Damaged/corroded wiring, Poor ground, Internal PCM driver fault. The specific cause varies by vehicle.
How much does it cost to fix P0693?
Repair costs vary widely depending on the root cause and vehicle.
Which vehicles are affected by P0693?
Au7o has documented P0693 across 1 vehicle models from 1 manufacturers: Jeep.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.