P0900 on 2005-2013 Toyota Yaris (MMT, Multimode, European market) — Clutch Actuator Circuit/Open
1 vehicles · 1 makes
How to diagnose and fix P0900: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Toyota Yaris · 2005–2013
This failure belongs to European-market Yaris fitted with Toyota's MMT (Multimode) automated manual transmission - an electrically operated robotised manual transmission with electric actuators for clutch and gear selection. It does not exist on the US-market four-speed automatic or on any Mazda-built Yaris. The clutch actuator can fail and lose the ability to hold or report clutch position. The gearbox then refuses to select a gear and the N on the gear position display flashes. Most owners hit it stationary, moments after switching on - the car simply will not take drive - but it also happens on the move, where the box drops out of the engaged gear and back into neutral, which is a loss of drive in traffic. UK actuator remanufacturers describe it as a frequent failure on MMT-equipped Yaris and commonly see fault codes such as P0810.
Common Symptoms
- Flashing N on the gear position display
- Car will not select a gear from standstill
- Gearbox drops into neutral while driving
- Loss of drive with the engine still running
- Transmission warning light
- Harsh or delayed engagement before total failure
How to Fix
Scan the transmission ECU first - stored codes help direct diagnosis, though codes alone do not prove the actuator rather than the clutch, mechanism or wiring is at fault. The conventional dealer answer is a new actuator assembly, which is expensive; the established alternative in the UK is a rebuild of the existing actuator by a remanufacturing specialist, which is cheaper than new, followed by any calibration Toyota or the specialist specifies. Have the clutch condition checked at the same time. No recall is cited for this - it is treated as a wear failure.
Sources for this issue (4)
- MMT gearbox problems - Clutch actuator (Toyota Owners Club UK)forum
- MMT gearbox yet again flashing N in drive positions - Yaris & Yaris Cross Club (Toyota Owners Club UK)forum
- Toyota MMT (Multimode) Clutch Actuator / Gearbox Malfunction - fault codes P0810 and P0900article
- Toyota MMT Clutch Actuator repair - common faultsarticle
Find P0900 by make
Browse every documented model and issue for your make.
P0900 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0900 mean?
P0900 stands for "Clutch Actuator Circuit/Open." The clutch actuator control circuit is open. On automated manual / dual-clutch transmissions the TCM drives a clutch actuator; an open circuit means it cannot control the clutch.
What are the most common causes of P0900?
The most common causes of P0900 are: Faulty clutch actuator, Open actuator control wiring, Corroded connector, Internal TCM driver fault. The specific cause varies by vehicle.
How much does it cost to fix P0900?
Repair costs vary widely depending on the root cause and vehicle.
Which vehicles are affected by P0900?
Au7o has documented P0900 across 1 vehicle models from 1 manufacturers: Toyota.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.