Known Issues/P0201/GMC

P0201 on GMC

Injector Circuit/Open - Cylinder 1

Critical2 GMC models affected$600-$6,500 typical repairSystem: Fuel System

P0201 on GMC vehicles indicates injector circuit/open - cylinder 1. Au7o has documented this code across 2 GMC models — most commonly on Sierra 2500HD, Sierra 3500HD. P0201 means the engine computer detected an electrical problem in the wiring or control circuit for the fuel injector on cylinder 1. The PCM pulses each injector open and back ground, and when it sees an open circuit, a short, or abnormal resistance on cylinder 1's injector circuit, it sets this code. In practice it means cylinder 1 may not be getting fuel injected properly, which can cause a misfire, rough running, or a no-start on that cylinder. It points to the injector itself or its wiring, not to a fuel-pressure problem affecting the whole engine. Typical repair costs on GMC range from $600 to $6,500, depending on the specific model and root cause.

Common Causes of P0201

  • •Damaged or corroded injector connector or terminals at cylinder 1
  • •Broken, chafed, or shorted injector wiring harness
  • •Failed (open or shorted) fuel injector on cylinder 1
  • •Loose or poor ground/power feed to the injector circuit
  • •Blown injector fuse or relay feeding the bank
  • •Failed injector driver inside the PCM/ECM

P0201 on GMC by Model

GMC Sierra 2500HD(1 issue)

  • LB7 Duramax Injector Body Cracking and Ball-Seat Erosion Causing Fuel-in-Oil Dilution2001-2004

    The 2001-2004 6.6L Duramax RPO LB7 uses injectors buried under the valve covers that are notorious for failing well before 150,000 miles. GM's own analysis attributed the failures to fuel injector body cracks, ball seat erosion, and high-pressure seal extrusion. A leaking injector dumps unburned diesel into the cylinder and past the rings into the crankcase, raising the oil level and diluting it. Owner reporting on duramaxforum.com and silveradosierra.com consistently puts first failures in the 100k-150k range, and because the injectors sit under the valve covers the labor to reach them is far higher than on the later LLY/LBZ engines, where injectors are accessible from the top. This is an LB7-only failure mode - the LLY and later injectors were redesigned and do not share it.

GMC Sierra 3500HD(1 issue)

  • Diesel Injector Failure Causing White Smoke and Rough Running2015-2024

    The Bosch piezoelectric fuel injectors on the Duramax L5P and LML engines can fail due to contaminated fuel, high-mileage wear, or internal electrical faults. A failed injector causes white smoke on startup, rough idle, misfires on the affected cylinder, and fuel dilution of the engine oil. The high fuel rail pressures (up to 36,000 PSI on the L5P) stress the injectors over time. Contaminated fuel from bulk diesel stations accelerates injector wear.

Looking for P0201 on a different make?

View P0201 across all makes →

Frequently Asked Questions

What does P0201 mean on GMC?▼

P0201 stands for "Injector Circuit/Open - Cylinder 1." P0201 means the engine computer detected an electrical problem in the wiring or control circuit for the fuel injector on cylinder 1. The PCM pulses each injector open and back ground, and when it sees an open circuit, a short, or abnormal resistance on cylinder 1's injector circuit, it sets this code. In practice it means cylinder 1 may not be getting fuel injected properly, which can cause a misfire, rough running, or a no-start on that cylinder. It points to the injector itself or its wiring, not to a fuel-pressure problem affecting the whole engine. On GMC specifically, this code is documented across 2 models.

What causes P0201 on GMC vehicles?▼

Common causes on GMC: Damaged or corroded injector connector or terminals at cylinder 1, Broken, chafed, or shorted injector wiring harness, Failed (open or shorted) fuel injector on cylinder 1, Loose or poor ground/power feed to the injector circuit, Blown injector fuse or relay feeding the bank. Specific causes vary by model and year — see the per-model sections below.

How much does it cost to fix P0201 on a GMC?▼

Repair costs on GMC range from $600 to $6,500, depending on the specific model and root cause.

Which GMC models have P0201 documented?▼

Au7o has documented P0201 on 2 GMC models: Sierra 2500HD, Sierra 3500HD.

Share:@au7o.io