2009 Toyota RAV4 Problems: 7 Known Issues

How to Fix

Check the complete VIN through Toyota's recall lookup or an authorized Toyota dealer. For an open C0M campaign, the dealer inspects the Power Window Master Switch and applies specialized lubricant if no abnormality is found; if an abnormality is found, the switch circuit board is replaced, free of charge. Smoke, a burning odor, heat or melting at the driver's-door switch warrants stopping window-switch use, shutting the vehicle off in a safe place and arranging prompt dealer inspection. Do not buy the removed generic switch search result as a substitute for the VIN-gated campaign remedy.

Owner tips & cautions

• TipUse the complete VIN to check C0M eligibility; engine, trim and model year alone do not confirm that the switch is included.
• WarningIf the switch emits smoke, heat or a burning odor, stop operating it and arrange prompt dealer inspection because the recalled condition can overheat and melt.

How to Fix

Check the complete VIN at Toyota's recall lookup or with an authorized Toyota dealer for open campaign G0V / NHTSA 16V-596. For an eligible vehicle that did not already receive both replacement arms under the prior recall, the dealer replaces both rear lower Suspension Arm No.1 assemblies, sets rear alignment, seals the arms with epoxy and applies labels stating that the arms are no longer adjustable, free of charge. If there is abnormal rear noise, a sudden alignment change or unstable handling, stop driving when safe and arrange prompt inspection. Do not substitute the removed aftermarket arm or undercoating search result for the recall remedy.

Owner tips & cautions

• TipUse the complete VIN to check G0V status; not every 2006-2011 RAV4 is included, and prior campaign history determines whether the current remedy remains open.
• WarningA new rear noise, alignment shift or unstable handling can precede arm separation; reduce risk and arrange dealer inspection promptly.

How to Fix

Check the full VIN through Toyota's recall lookup or an authorized Toyota dealer and confirm completion of both 11V-113/90L and 10V-017/A0A when applicable. The 90L remedy modifies or replaces the pedal as specified and addresses incompatible Toyota all-weather mats; the A0A remedy installs Toyota's reinforcement bar in the affected CTS pedal. Use only the correct driver mat secured by its retaining clips and never stack mats. If acceleration continues after releasing the pedal, apply firm steady braking without pumping, shift to Neutral when safe, steer to a safe stop and shut the engine off only after stopping.

Owner tips & cautions

• WarningDo not assume a completed floor-mat campaign also completed the separate sticking-pedal campaign; ask the dealer to check both recall numbers by VIN.
• TipKeep the driver's footwell clear and verify that the correct mat is attached to both retention points with no second mat underneath it.

How to Fix

Ask Toyota for the VIN's LSC 90K completion history and inspect the VVT-i oil hose and engine-oil level. If the oil-pressure warning appears, a large leak develops or abnormal engine noise begins, shut the engine off and arrange service rather than continuing to drive. Because the campaign has expired, do not promise a free repair. Have Toyota or a qualified technician identify the current VIN-correct service parts and inspect for lubrication damage if the engine ran low. Do not order the prior all-metal pipe and two gasket searches as though they were Toyota's campaign remedy.

Owner tips & cautions

• WarningStop the engine for an oil-pressure warning, major leak or abnormal engine noise; continuing to run a low-oil engine can turn a hose repair into engine damage.
• TipAsk Toyota for the VIN's LSC 90K completion history before paying for repeat work, while recognizing that the campaign itself expired in 2021.

How to Fix

Follow T-SB-0046-10's sequence: check for the supported DTCs; if none are stored, active-test the purge VSV at warm idle; then disconnect and inspect the specified tank-to-canister and canister-to-key-off-pump hoses for liquid fuel. If the gates are not met, the bulletin does not apply and normal EVAP diagnosis continues. If fuel is confirmed, the required tank, canister and possibly canister-filter/protector scope depends on which hose contains fuel. Do not replace a gas cap, vent valve or full canister from a generic code list. The former federal and California emissions-warranty windows are expired; obtain a diagnosis and estimate first.

Owner tips & cautions

• TipSave freeze-frame data and all EVAP codes before clearing them; the bulletin requires exact code/test and liquid-fuel confirmation gates.
• WarningDo not guess at an EVAP canister, gas cap or vent valve from a generic code; T-SB-0046-10's component scope changes based on where liquid fuel is found.

How to Fix

First determine whether the entire visor base moves or pulls away from the headliner, or whether only the visor blade loses angle at its internal pivot. If the base is loose and the VIN falls within T-SB-0068-10, have a qualified trim/body technician inspect the roof-panel mounting area and perform the bracket/support procedure. If the base is secure but the blade droops, identify the exact visor assembly by VIN, side, color, illumination and vanity-mirror equipment before approving replacement. The original 36-month/36,000-mile bulletin warranty is expired; obtain a written diagnosis and quote.

Owner tips & cautions

• TipPhotograph the base while gently moving the visor so the shop can see whether the roof/headliner mount moves or only the visor blade droops.
• WarningDo not glue a damaged roof-panel mount or order a visor by model year alone; the TSB repair and visor assembly vary by the diagnosed failure and vehicle equipment.

How to Fix

Check the VIN, original paint code and date of first use with an authorized Toyota dealer. Toyota's primary coverage ended December 11, 2022; secondary coverage was 10 years from first use regardless of mileage, so most vehicles are now outside the program and any remaining 2017 eligibility is date-specific. The dealer must confirm program eligibility and inspect the panel under Toyota's procedure before coordinating a qualifying repaint. Damage excluded by the program may require customer-paid repair first. Do not use a touch-up pen or generic repaint search result as the remedy for widespread adhesion loss.

Owner tips & cautions

• TipPhotograph every affected metal panel before repair and ask the dealer to document VIN eligibility, paint code, date of first use and the ZKG inspection result.
• WarningA touch-up pen can conceal a small chip but does not correct the adhesion failure described by ZKG.