P0734 on Jeep
Gear 4 Incorrect Ratio
P0734 on Jeep vehicles indicates gear 4 incorrect ratio. Au7o has documented this code across 1 Jeep model — most commonly on Grand Cherokee. This code means the Transmission/Powertrain Control Module detected an incorrect gear ratio in 4th gear. The module continuously compares input shaft speed to output shaft speed; if the ratio in 4th gear doesn't match the expected value, it sets P0734. This usually indicates the transmission is slipping or not fully engaging 4th gear due to a hydraulic, friction, or solenoid problem. Symptoms include slipping, flaring RPM, harsh or missed shifts, and possibly limp mode. Typical repair costs on Jeep range from $300 to $3,500, depending on the specific model and root cause.
Common Causes of P0734
- •Low or degraded/burnt transmission fluid
- •Slipping clutch packs or worn friction elements in 4th gear
- •Stuck or faulty shift solenoid
- •Valve body / internal hydraulic leak or restriction
- •Worn or failing torque converter
- •Faulty input or output speed sensor
- •Internal mechanical wear (bands, planetary gears)
P0734 on Jeep by Model
Jeep Grand Cherokee(1 issue)
- W5A580 (NAG1) 5-Speed Automatic Limp Mode and Harsh Shift from Conductor-Plate Speed Sensors and Fluid Contamination2005-2013
The Mercedes-derived W5A580 (NAG1) 5-speed automatic used in WK and early WK2 Grand Cherokees is mechanically strong but suffers well-documented electronic and fluid-related failures. Faulty conductor-plate speed sensors and shift-pressure solenoids drop the transmission into limp mode (stuck in a single gear). Contaminated or degraded fluid (including water intrusion past the dipstick/fill-tube seal) causes torque-converter-clutch shudder, harsh or delayed shifts, and a knock on coasting downshifts. The 13-pin connector adapter can also leak, wicking fluid into the harness by capillary action.
Looking for P0734 on a different make?
View P0734 across all makes →Frequently Asked Questions
What does P0734 mean on Jeep?▼
P0734 stands for "Gear 4 Incorrect Ratio." This code means the Transmission/Powertrain Control Module detected an incorrect gear ratio in 4th gear. The module continuously compares input shaft speed to output shaft speed; if the ratio in 4th gear doesn't match the expected value, it sets P0734. This usually indicates the transmission is slipping or not fully engaging 4th gear due to a hydraulic, friction, or solenoid problem. Symptoms include slipping, flaring RPM, harsh or missed shifts, and possibly limp mode. On Jeep specifically, this code is documented across 1 model.
What causes P0734 on Jeep vehicles?▼
Common causes on Jeep: Low or degraded/burnt transmission fluid, Slipping clutch packs or worn friction elements in 4th gear, Stuck or faulty shift solenoid, Valve body / internal hydraulic leak or restriction, Worn or failing torque converter. Specific causes vary by model and year — see the per-model sections below.
How much does it cost to fix P0734 on a Jeep?▼
Repair costs on Jeep range from $300 to $3,500, depending on the specific model and root cause.
Which Jeep models have P0734 documented?▼
Au7o has documented P0734 on 1 Jeep model: Grand Cherokee.