2005 model year · 0+ owner reports · Updated April 2026
According to Au7o's analysis of 0+ owner reports, the 2005 Nissan Sentra has 4 documented known issues, with 1 rated critical. The most serious is Front Strut Tower Rust and Corrosion Leading to Suspension Separation Risk ($1,000-$4,000 repair). Across all issues, repair costs range from $150 to $4,000. DIY maintenance guides at au7o.io.
On the 2002-2006 Nissan Sentra, a serious rust issue on 2002-2006 Sentras involves corrosion of the front strut housing/tower area, especially in states using heavy road salt. As corrosion progresses, the strut can break through the surrounding structure, causing sudden changes in steering and suspension geometry. Nissan recalled affected vehicles in salt-belt states because the condition can compromise vehicle control.
Inspect both front strut tower areas from above and below for perforation, flaking metal, deformation, or contact between the strut and body. If corrosion is present, follow recall inspection procedures; repair may involve reinforcement plates or, in severe cases, vehicle buyback/scrappage depending on condition and campaign status. Do not continue driving if the tower is visibly separating.
Parts and tips from 0+ owners who fixed this issue
On the 2000-2006 Nissan Sentra, in rust-belt climates, the Sentra's steel fuel filler neck commonly corrodes where road salt and debris collect behind the left rear wheel area. Owners report a strong gasoline odor after fill-ups, visible rust holes, EVAP leak codes, and in some cases fuel dripping during refueling. Nissan issued a recall on certain vehicles for corrosion of the filler tube that could lead to fuel leakage.
Inspect the filler neck and vent tube for scaling, pinholes, and wet fuel residue, especially near the wheelhouse and hose connections. Replace the filler neck assembly and any degraded hoses or clamps, then clear EVAP codes and confirm the system passes a smoke test. In severe rust areas, inspect surrounding body metal and shield liners as well.
Parts and tips from 0+ owners who fixed this issue
On the 2002-2006 Nissan Sentra, a common failure on B15 Sentras is deterioration of the crankshaft position sensor and, less often, the camshaft position sensor. Owners report sudden stalling while driving, extended cranking, or a hot no-start condition that becomes more frequent over time. Nissan issued service information for engine stall/no-start conditions tied to these sensors, and owner complaints frequently mention the engine cutting out without much warning.
Scan for stored crank/cam correlation or signal-loss codes and monitor RPM signal during cranking. Inspect the sensor connectors and harness near the transmission bellhousing and timing cover area, then replace the failed OEM sensor(s) with updated parts. Clear codes and verify hot restart and road-test operation after replacement.
Parts and tips from 0+ owners who fixed this issue
On the 2000-2006 Nissan Sentra, many owners of this generation Sentra report recurring front brake pulsation caused by rotor thickness variation or heat-related warping. The issue often appears after relatively short service intervals, especially with low-quality replacement rotors or sticking caliper slide hardware. Drivers feel steering wheel shake and pedal pulsation during highway-speed braking, even when pads still have usable material.
Measure rotor runout and thickness variation, inspect caliper slides and pad wear patterns, and verify proper wheel lug torque. Replace or machine rotors if still within spec, install quality pads and hardware, and service or replace sticking calipers/slides as needed. Proper bedding-in and torque sequence help reduce repeat issues.
Parts and tips from 0+ owners who fixed this issue
AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
Nissan North America, Inc. (Nissan) is recalling certain 2001-2003 Maxima, 2002-2006 Sentra, 2002-2004 Pathfinder, 2007-2011 Versa Sedan and Versa Hatchback, 2001-2004 Infiniti I30 and I35, 2002-2003 Inifiniti QX4, 2003-2008 Infiniti FX35 and FX45 and 2006-2010 M35 and M45 vehicles. The vehicles are equipped with non-desiccated, frontal passenger air bag inflators containing phase stabilized ammonium nitrate (PSAN) propellant that were used as interim remedy parts for previous Takata recalls. These inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.
AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE
Nissan North America, Inc. (Nissan) is recalling certain 2002-2006 Sentra vehicles whose passenger air bags were previously inspected and may have been released without replacing the Takata air bag inflator. In the event of a crash, Takata frontal passenger air bag inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.
AIR BAGS
Nissan North America, Inc. (Nissan) is recalling certain model year 2001-2003 Nissan Maxima, 2002-2004 Pathfinder, 2002-2006 Sentra, 2002-2003 Infiniti QX4 and I35, 2003 FX35 and FX45, and 2001 I30 vehicles. Upon deployment of the passenger side frontal air bag, excessive internal pressure may cause the inflator to rupture.
ENGINE AND ENGINE COOLING
CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.5L ENGINES MAY EXPERIENCE EXCESSIVE ENGINE OIL CONSUMPTION AS A RESULT OF IMPROPER PERFORMANCE OF THE PISTON RINGS.
ENGINE AND ENGINE COOLING
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.
+ 12 more recalls. Check all on NHTSA.gov
Enter your VIN at NHTSA.gov to check recalls specific to your vehicle.
Don't see your problem? Describe your symptoms to get a diagnosis, or get a full repair guide.
According to Au7o's analysis of 0+ owner reports, the 2005-2005 Nissan Sentra has 4 documented issues. The most frequently reported are: Front Strut Tower Rust and Corrosion Leading to Suspension Separation Risk, Fuel Filler Neck Corrosion and Rust-Through Triggering EVAP Leaks and Fuel Smell, Crankshaft and Camshaft Position Sensor Failure Causing Intermittent Stall or No-Start. Of these, 1 is rated critical and should be addressed promptly.
The 2005-2005 Nissan Sentra has 4 known issues documented across 0+ owner reports. 1 issue is rated critical: Front Strut Tower Rust and Corrosion Leading to Suspension Separation Risk. Prospective buyers should inspect for these issues and factor potential repair costs into their purchase decision. Regular maintenance following the manufacturer's schedule helps prevent many common problems.
Repair costs for known Nissan Sentra issues range from $150 to $4,000, depending on the specific problem and whether you choose DIY or professional repair. The most critical issue, Front Strut Tower Rust and Corrosion Leading to Suspension Separation Risk, typically costs $1,000-$4,000 to repair. Au7o provides step-by-step DIY maintenance guides that can help reduce repair costs.
A serious rust issue on 2002-2006 Sentras involves corrosion of the front strut housing/tower area, especially in states using heavy road salt. As corrosion progresses, the strut can break through the surrounding structure, causing sudden changes in steering and suspension geomet… Repairs typically run $1,000-$4,000. Severity: high.
In rust-belt climates, the Sentra's steel fuel filler neck commonly corrodes where road salt and debris collect behind the left rear wheel area. Owners report a strong gasoline odor after fill-ups, visible rust holes, EVAP leak codes, and in some cases fuel dripping during refuel… Repairs typically run $250-$700. Severity: medium.
A common failure on B15 Sentras is deterioration of the crankshaft position sensor and, less often, the camshaft position sensor. Owners report sudden stalling while driving, extended cranking, or a hot no-start condition that becomes more frequent over time. Nissan issued servic… Repairs typically run $150-$450. Severity: medium.
Many owners of this generation Sentra report recurring front brake pulsation caused by rotor thickness variation or heat-related warping. The issue often appears after relatively short service intervals, especially with low-quality replacement rotors or sticking caliper slide har… Repairs typically run $200-$700. Severity: low.
Content on this page was compiled with AI assistance using NHTSA complaints, TSBs, owner reports, and public automotive data. While we strive for accuracy, this information may contain errors. Always verify repair procedures and specifications with your vehicle's service manual or a qualified mechanic.
