According to Au7o's research across NHTSA recalls, manufacturer TSBs, and owner forum reports, the 2008 Toyota Hilux has 1 documented issue, with 1 rated critical. The most serious is 1KD-FTV Injector Wear and Leaking Seat Washers Trigger Injector Malfunction ($400-$3,200 repair). Across all issues with published estimates, repair costs range from $400 to $3,200. DIY maintenance guides at au7o.io.
On the 2005-2015 Toyota Hilux, the 1KD-FTV 3.0-litre D-4D was Toyota's first four-cylinder common-rail diesel, and its injectors are the engine's best-known weak point. P1238 on this engine is Toyota's Injector Malfunction code: the ECM compares crankshaft acceleration cylinder-by-cylinder and flags the cylinder whose combustion is out of family. Toyota's own diagnostic listing for the code names the injector, the EDU, an open or short in the engine wiring harness, connector condition, compression pressure and valve clearance as the trouble areas — in that order of likelihood on a high-mileage truck.
Two distinct mechanical faults produce the code on the Hilux, and they often occur together. The first is straightforward injector wear. Rail pressures from roughly 30 to 160 MPa, multiple injection events per stroke and very tight internal clearances mean the nozzles wear out; failures cluster around 120,000-140,000 km, though poor fuel or a neglected filter can bring one down at 75,000 km. The second is the injector seat washer. On the 2005-2007 trucks the original copper seat design deteriorates, letting combustion blow-by past the injector into the rocker cover, where it carbonises the engine oil. That contaminated oil blocks the sump pickup and starves the bearings and turbo — which is why an ignored P1238 on this engine can end as a spun bearing or a failed turbocharger rather than just a rough-running cylinder.
Owners describe a loud cold-start knock or rattle, white smoke on start-up, an erratic idle, roughness under load at low rpm, worse fuel economy and a check engine light that may only appear intermittently at first. On 4x4 forums the same picture recurs on 2008-era 3.0 D-4D trucks: pending fuel-rail and injector codes including P1238, no dramatic driveability complaint yet, and a diesel shop confirming worn injectors on the bench. Note that the code is not injector-exclusive — cases on 1KD engines have traced back to a cracked piston or low compression — so the mechanical checks below are not optional. Because the truck often still drives, the fault is frequently deferred, which is the worst outcome, since a leaking injector can wash the bore and, via the oil contamination path, take the turbo with it.
Confirm which cylinder the ECM is flagging and then prove the mechanical cause before spending money. Read injector correction and cylinder-balance data with a Toyota-capable tool, then remove the leak-off lines and run a return-flow test: the cylinder dumping noticeably more fuel back to the tank at idle and at a raised rpm is the failing injector. Follow with a compression test and a valve-clearance check on the flagged cylinder, because Toyota lists insufficient compression and valve clearance as causes of this exact code and no injector will fix a mechanical shortfall — owners have found cracked pistons behind a P1238 on this engine. Also check the wiring: inspect the injector harness and connectors for chafing and corrosion and check the EDU, since a broken driver or damaged harness can mimic a mechanical fault. The definitive test remains bench-testing the removed injectors at a diesel injection specialist.
While the injectors are out, inspect the injector bores and seats. Carbon build-up, a scorched or pitted seat, or a crushed copper washer means the seat has been leaking; the bore must be cleaned and reamed with the proper seat cutter and new washers fitted, or the new injector will leak in exactly the same way. If blow-by has been leaking for a while, drop the sump and check the pickup screen for the carbonised oil sludge that is characteristic of this engine, and change the oil and filter immediately after the repair — leaving contaminated oil in place is what turns an injector job into a bearing or turbo failure.
Replace injectors as a matched set of four rather than one at a time, using genuine Denso units or properly remanufactured ones, and program each injector's compensation code into the ECM. Fit new seat washers and new high-pressure pipes, torque everything to spec, and perform the injector learn procedure. Given the failure interval, many owners on high-kilometre trucks now treat injectors as a service item and plan a replacement around 100,000 km with diagnostic checks at each service. Expect roughly $400-$800 for one injector supplied, fitted and coded; a full set of four with washers and labour typically lands between $1,500 and $3,200, and materially more if the sump has to come off or the turbo has been damaged.
According to Au7o's research across NHTSA recalls, manufacturer TSBs, and owner forum reports, the 2008 Toyota Hilux has 1 documented issue. The documented issue is: 1KD-FTV Injector Wear and Leaking Seat Washers Trigger Injector Malfunction. Of these, 1 is rated critical and should be addressed promptly.
Is the Toyota Hilux reliable?
The 2008 Toyota Hilux has 1 known issue compiled from NHTSA recalls, manufacturer TSBs, and owner forum reports. 1 issue is rated critical: 1KD-FTV Injector Wear and Leaking Seat Washers Trigger Injector Malfunction. Prospective buyers should inspect for these issues and factor potential repair costs into their purchase decision. Regular maintenance following the manufacturer's schedule helps prevent many common problems.
How much does it cost to fix common Toyota Hilux problems?
Repair costs for known Toyota Hilux issues range from $400 to $3,200, depending on the specific problem and whether you choose DIY or professional repair. The most critical issue, 1KD-FTV Injector Wear and Leaking Seat Washers Trigger Injector Malfunction, typically costs $400-$3,200 to repair. Au7o provides step-by-step DIY maintenance guides that can help reduce repair costs.
What is the 2005-2015 Toyota Hilux 1KD-FTV Injector Wear and Leaking Seat Washers Trigger Injector Malfunction?
The 1KD-FTV 3.0-litre D-4D was Toyota's first four-cylinder common-rail diesel, and its injectors are the engine's best-known weak point. P1238 on this engine is Toyota's Injector Malfunction code: the ECM compares crankshaft acceleration cylinder-by-cylinder and flags the cylind… Repairs typically run $400-$3,200. Severity: high.
Content on this page was compiled with AI assistance using NHTSA complaints, TSBs, owner reports, and public automotive data. While we strive for accuracy, this information may contain errors. Always verify repair procedures and specifications with your vehicle's service manual or a qualified mechanic.
